The way to prevent the iron going into the impact crusher

We should know that impact crusher is needed in industry production, so with the development of science and technology, many different kinds of crushers are constantly increasing and the production process also has the very big difference.

 

Today, I would like to give you a brief introduction about how to prevent the iron going into the impact crusher. In fact, this is quite simple, as long as the cause of the frequent failure to be found and then mend it making this as a starting point for processing. In fact, we can mainly deal with it from three aspects of processing.

 

First, we need to check the belt, funnel and liner of the impact crusher then find out fault point to deal with it. In addition to remind you that if there is a problem it must be replaced. We install the detector above the feeding device, which is mainly to detect any iron into impact crusher. Find out through the detector it also can avoid damage.

Pre:The adjustment of the jaw crusher for the the grain size of the material

Next:How to do when the impact crusher doesn’t work?