.jpg)
The adjustment of the jaw crusher for the the grain size of the material
2016-12-31
The adjusting device of the jaw crusher is used to adjust the size of the discharge port of the crusher. The cumulative time machine operation, tooth plate wear, the discharge size will continue to change, the product size becomes coarse, it must be re adjusted by the analysis of the main reason is that the movable jaw crusher teeth plate force to transfer gear, gear force after reverse rotation, which leads to the movable tooth plate and the fixed tooth plate gap becomes larger.
In view of this situation, Juxin Machinery technician adjust the device to make the following improvements: the adjustment of a screw to maintain the original right hand, and the other to the left, on both sides of the gear convex be set six square.
When adjust it, take the middle gear, the gear to be tightened evenly on both sides, adjust the appropriate clearance, and then insert the middle gear, the intermediate gear for the positioning effect. After adjusting the jaw crusher for customer, it did not appear big gap condition.
In order to ensure the crusher equipment is in good technical condition, ready to be put into operation, reduce downtime, improve the utilization rate of the intact rate, crusher, crushing machine to reduce wear and prolong the service life of the crusher; do regular maintenance, force, correctly handle the use of maintenance and repair, not only do not keep or allow just don't keep.
